[coldfire-gnu-discuss] Connecting to a Coldfire target using P&E USB Coldfire Multilink.

[Nathan Sidwell]

Claude Sylvain wrote:

Thanks for the detailed report.

> - From that point, I compiled a little project and connected to the
>   target using GDB.
>   From GDB, when executing a "load" command, there was error(s), and I
>   have to make many "load" to finally have the command work correctly.
>   I tryed also to exit GDB, re-execute GDB.  Also disconnect/re-connect the
>   USB Multilink without success.

What errors did you get at this point?


> Remark:
> 
> - This morning, I installed Sourcery G++ Lite on another (Windows XP Pro)
>   computer, and I saw a popup window telling that P&E driver was installed.
>   There was no request to restart the computer.
>   I have not the USB Multilink for Coldfire here, so I can not test
>   if the installed driver is functionnal.

If you can see if that works before rebooting, that would be helpful.

It might be that the P&E install should be requesting a reboot.

nathan

-- 
Nathan Sidwell    ::   http://www.codesourcery.com   ::         CodeSourcery
nathan at codesourcery.com    ::     http://www.planetfall.pwp.blueyonder.co.uk