[coldfire-gnu-discuss] Connecting to a Coldfire target using P&E USB Coldfire Multilink.

[Carlos O'Donell]

On Mon, Dec 11, 2006 at 11:47:35AM -0500, Claude Sylvain wrote:
> - From that point, I compiled a little project and connected to the
>   target using GDB.
>   From GDB, when executing a "load" command, there was error(s), and I
>   have to make many "load" to finally have the command work correctly.
>   I tryed also to exit GDB, re-execute GDB.  Also disconnect/re-connect the
>   USB Multilink without success.
> 
> - After I have done a Poweroff and Poweron (the following day), all
>   was working like a charm !

Please read the section "Installing P&E Drivers" of the "Getting
Started" guide. It covers the correct sequence to try if you have
problems with the P&E drivers.

Cheers,
Carlos.
-- 
Carlos O'Donell
CodeSourcery
carlos at codesourcery.com
(650) 331-3385 x716