[mel-discuss] BeagleBoard-XM booting problem

[Govind Mukundan]

Hi,

I am quite new to linux development. I downloaded the installer yesterday
and followed the instructions outlined in the quick start guide. But I am
not able to bootup. I am using a Beagle-XM revC board. (the board works
fine with the shipped angstrom image)

My first error was the "could not find /boot/uImage". I resolved this by
following both the workarounds mentioned in a previous thread (
http://sourcerytools.com/pipermail/mel-discuss/2012-February/000006.html),
after this now I get an error - "wrong image type for bootm command". Could
anyone tell me how to fix this? My full log is below:

----------------------- debug log start ----------------------------

U-Boot SPL 2011.12-dirty (Jan 30 2012 - 00:39:30)
Texas Instruments Revision detection unimplemented
OMAP SD/MMC: 0
timed out in wait_for_bb: I2C_STAT=1000
reading u-boot.img
reading u-boot.img


U-Boot 2011.12-dirty (Jan 30 2012 - 00:39:30)

OMAP3630/3730-GP ES1.2, CPU-OPP2, L3-165MHz, Max CPU Clock 1 Ghz
OMAP3 Beagle board + LPDDR/NAND
I2C:   ready
DRAM:  512 MiB
NAND:  0 MiB
MMC:   OMAP SD/MMC: 0
*** Warning - readenv() failed, using default environment

In:    serial
Out:   serial
Err:   serial
Beagle xM Rev C
No EEPROM on expansion board
No EEPROM on expansion board
Die ID #04ae00029ff800000163810c13024011
Net:   Net Initialization Skipped
No ethernet found.
Hit any key to stop autoboot:  0
The user button is currently NOT pressed.
SD/MMC found on device 0
reading uEnv.txt

156 bytes read
Loaded environment from uEnv.txt
Importing environment from mmc ...
reading boot.scr

400 bytes read
Running boot.scr script from mmc ...
## Executing script at 80200000
reading uImage

328616 bytes read
## Booting kernel from Legacy Image at 80200000 ...
   Image Name:   U-Boot 2011.12-dirty for beagle
   Image Type:   ARM U-Boot Firmware (uncompressed)
   Data Size:    328552 Bytes = 320.9 KiB
   Load Address: 80100000
   Entry Point:  00000000
   Verifying Checksum ... OK
Wrong Image Type for bootm command
ERROR: can't get kernel image!
Booting from nand ...

no devices available
## Booting kernel from Legacy Image at 80200000 ...
   Image Name:   U-Boot 2011.12-dirty for beagle
   Image Type:   ARM U-Boot Firmware (uncompressed)
   Data Size:    328552 Bytes = 320.9 KiB
   Load Address: 80100000
   Entry Point:  00000000
   Verifying Checksum ... OK
Wrong Image Type for bootm command
ERROR: can't get kernel image!



----------------------- debug log end ----------------------------

Thanks,
Govind
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://sourcerytools.com/pipermail/mel-discuss/attachments/20120305/184084d7/attachment.html>