m68k-elf-sprite 4.2-125 crashing -

[Matt Cohn]

Hia,

I am debugging a M52233DEMO board using the P&E USB BDM.  I connect to it
via m68k-elf-sprite.  I turned on the verbose console and put the sprite in
verbose mode, and here's the problem I'm experiencing.

Usually debugging will work fine for a while.  I will be able to continue,
suspend, step, break, and continue again without problems.  After leaving
the program running for a while (a couple minutes) or doing a lot of
stepping (anywhere, not in one particular place) I will experience the
following.  

If the code was running and I try to do a suspend, m68k-elf-sprite uses a
lot of CPU and doesn't respond.  Eventually GDB times out with "Target
request failed: Failed to interrupt".  During this there is no response on
the console.

If I was stepping through the code when the problem happened, I will see the
following on the console:
m68k-elf-sprite: Step at 0x0
m68k-elf-sprite: error: Lost connection to hardware device
m68k-elf-sprite: Sent response: 'E.fatal.Lost connection to hardware device'
Error from remote target: Lost connection to hardware device

I should also note that occasionally (about 1/5th of the time) when
programming my board using CF Flasher, it will hang, timeout, fail
validation and need to be flashed again.  Flashing again works fine.  I have
tried disconnecting all of my USB devices, using a different USB port, and
killing all background processes and services to no avail.  Any advice is
sincerely appreciated.

Thank you very much,
--Matt